top bar

Difference between revisions of "Skyra"

m
Line 6: Line 6:
 
<tr><td>'''Devices:'''</td><td>[https://www.coboltlasers.com/lasers/multi-line-laser www.coboltlasers.com/lasers/multi-line-laser]</td></tr>
 
<tr><td>'''Devices:'''</td><td>[https://www.coboltlasers.com/lasers/multi-line-laser www.coboltlasers.com/lasers/multi-line-laser]</td></tr>
 
<tr><td>'''Since Version:'''</td><td>April 6, 2020</td></tr>
 
<tr><td>'''Since Version:'''</td><td>April 6, 2020</td></tr>
<tr><td>'''Example Config File:'''</td><td></td></tr>
 
 
</table>
 
</table>
 +
 +
=== Description ===
 +
The Skyra is a multi-line laser from Cobolt.
 +
 +
===The serial port===
 +
* 115,200 or 19200 baud,
 +
* no flow control,
 +
* one stop bit
 +
* no parity
 +
* 8 data bits
 +
* delaybetweenChars 0 ms.
 +
 +
This driver supports '''automatic serial port detection'''.
 +
 +
=== Notes ===
 +
 +
{{Note|Lasers will ignore the power setting for a few minutes while they start up. Re-set power/current after warm up is over}}
 +
 +
{{Note|If the Laser has '''aborted''', you could issue a '''restart''' command via the Serial Command property, followed by a key cycle to restart the laser.}}
 +
 +
=== Device Properties===
 +
 +
The new driver supports constant current, constant power, and modulation modes. Also, you can select Analog or Digital modulation. The ability to enable/disable Autostart is now supported. There is also direct serial communication supported via '''Serial Command'''
 +
 +
 +
[http://micro-manager.3463995.n2.nabble.com/template/NamlServlet.jtp?macro=search_page&node=3463995&query=Skyra Click here to search for Skyra on the Micro-Manager mailing list archive.]

Revision as of 10:51, 10 April 2020

Summary:Skyra Laser Controller
Author:Karl Bellve
License:LGPL
Platforms:All
Devices:www.coboltlasers.com/lasers/multi-line-laser
Since Version:April 6, 2020

Description

The Skyra is a multi-line laser from Cobolt.

The serial port

  • 115,200 or 19200 baud,
  • no flow control,
  • one stop bit
  • no parity
  • 8 data bits
  • delaybetweenChars 0 ms.

This driver supports automatic serial port detection.

Notes

Note
Lasers will ignore the power setting for a few minutes while they start up. Re-set power/current after warm up is over
Note
If the Laser has aborted, you could issue a restart command via the Serial Command property, followed by a key cycle to restart the laser.

Device Properties

The new driver supports constant current, constant power, and modulation modes. Also, you can select Analog or Digital modulation. The ability to enable/disable Autostart is now supported. There is also direct serial communication supported via Serial Command


Click here to search for Skyra on the Micro-Manager mailing list archive.

© Micro-Manager : Vale Lab, UCSF 2006-2011 | All Rights Reserved | Contact