top bar

Difference between revisions of "Neos"

(warn that parallel port only works on LPT1)
(2 intermediate revisions by one other user not shown)
Line 16: Line 16:
--[[User:Nico|Nico]] 15:34, 15 August 2007 (PDT)
--[[User:Nico|Nico]] 15:34, 15 August 2007 (PDT)

Latest revision as of 05:58, 18 April 2012

AOTF adapter

Summary:Controls NEOS AOTF through PCs parallel port
Author:Nenad Amodaj
License:BSD License
Platforms:Windows only
Example Config File:Media:MMConfig_AOTF.cfg

This adapter lets you use a NEOS AOTF(and other shutter devices that can be controlled with a TTL) as a shutter using just your PCs parallel port. The pins on the parallel port are addressed using a binary mask with a maximum value of 1024 (so that you can address the first 10 pins of the parallel port, see the ParallelPort for examples). Each pin (or a combination thereof) can be declared to be a shutter.

In general, it is a better approach to use a DAQ board to control an AOTF (since that will also give you control of intensity). However, this adapter might still be useful as it provides TTLs in a very cost-effective way.

This adapter uses the inpout.dllto talk to the parallel port.

--Nico 15:34, 15 August 2007 (PDT)

Note: This Windows driver only works with your LPT1 built-in ParallelPort connector. Daughter ParallelPort cards will not work with Micro-Manager.

Consider an Arduino or a computer I/O board if your computer does not have an LPT1 port.

© Micro-Manager : Vale Lab, UCSF 2006-2011 | All Rights Reserved | Contact