top bar

Difference between revisions of "LeicaDMI"

(Leica DMI adapter)
m (Leica DMI adapter)
Line 26: Line 26:
<tr><td><b>Peripheral device detection:</b></td><td>Supported</td></tr>
<tr><td><b>Peripheral device discovery:</b></td><td>Supported</td></tr>

Revision as of 13:57, 22 April 2011

Leica DMI adapter

Summary:Controls Leica DMI and DM microscopes
Platforms:Windows, Mac OS X and Linux (serial port)
Devices:DMI4000, DMI5000, DMI6000, DM4000, DM5000, and DM6000 microscopes. Some success (and failures) have been reported with microscopes using the CTR MIC control box (DMLA100, DMLALED, DMLFSA, DMRXA2, DMRA2, and DMIRE2).
Scope, Shutter (external and internal), Reflectorturret, SideportTurret, ObjectiveTurret, Excitation Lamp Switcher, Z-drive, XY-stage, DIC-turret
Available since version:1.3.18
Serial port settings:
AnswerTimeout 5000
BaudRate 19200
DelayBetweenCharsMs 0
Handshaking Off or software
Parity None
StopBits 1
Peripheral device discovery:Supported

This adapter controls Leica DMI microscopes through a direct serial interface. It was build for and tested with a DMI600B, but might work with other DMI models as well.

To use this adapter when your microscope only has a USB connector, install the drivers provided by Leica (on Windows), or the drivers from FTDI (on Mac OS X and Linux) to drive the USB to serial interface inside the microscope (no other Leica drivers are needed since the adapter communicates directly through the serial interface). This allows you to connect to the microscope through the USB cable. In the Hardware configuration Wizard, select the 'Leica' serial port (on Windows) or the FTDI port (Mac and Linux) and configure it to run at 19200 baud and have a delay between chars of 0 (other settings are standard). You will always need to 'Add' the LeicaDMI Scope device (and have it use the serial port you just configured).

You will need to define all hardware that is part of your microscope in the Hardware Configuration Wizard (i.e., Micro-Manager does not query the microscope itself for devices present). Most labels (reflectors, objectives, sideport) will be read from the controller, so you do not need to set those in the Hardware Configuration Wizard.

© Micro-Manager : Vale Lab, UCSF 2006-2011 | All Rights Reserved | Contact