top bar

Cobolt

Revision as of 07:51, 5 June 2009 by Kdb (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Summary:Cobolt Laser Controller
Author:Karl Bellve.
License:LGPL
Platforms:All
Devices:[1]
Since Version:Future
Example Config File:

The Cobolt laser controller controls compact solid-state lasers.

Before adding this device adapter, confirm that you have serail communication with the laser controller by using a terminal. The serial port should be set at set at 19200 baud, no flow control, one stop bit, no parity, 8 data bits, delaybetweenChars 0 ms. The laser controller should respond to the following commands: l?, p?, hrs? (Laser on/off, power, hours). If you do not get a response then the Cobolt device adapter will not work.

In the configuration wizard you will need to add one Cobolt object for every Cobolt laser you would like to control.

The following commands are available with this device adapter:

  • Laser Power (Read/Write)
  • Laser On/Off (Read/Write)
  • Laser Status (Read only)
  • Hours (Read only)
  • Serial Number (Read only)
  • Interlock state (Read only)
  • Current (Read only)
  • Errors (Read only)
   NOTE: Lasers will automatically be shut off when Micromanager closes (power remains on).


--Karl Bellve, Biomedical Imaging Group, University of Massachusetts 15:51, 5 June 2009 (UTC)

© Micro-Manager : Vale Lab, UCSF 2006-2011 | All Rights Reserved | Contact